Silverstone TJ11 v-edition

Quote:

---

Originally Posted by Systemlord

Does anyone know the width, height and length of just the bottom compartment of the TJ11? My plan is to install 2x 140mm radiators with 120mm fans using 120->140mm adapters, almost all of the adapters are 15mm thick so I need to figure out if there is enough width for the rads, 15mm adaptors and the fans.

Thank you

---

http://www.silverstonetek.com/produc...id=292&area=en

From their manual :

204mm(witdh) x 630mm (length) x 154 (height) - Page 41 on the manual

You would be able to fit them just fine I would imagine. I will be getting this case next week and plan on having a quad 140mm and a triple 140mm using 120mm fans.

Quote:

---

Originally Posted by nksharp

http://www.silverstonetek.com/produc...id=292&area=en

From their manual :

204mm(witdh) x 630mm (length) x 154 (height) - Page 41 on the manual

You would be able to fit them just fine I would imagine. I will be getting this case next week and plan on having a quad 140mm and a triple 140mm using 120mm fans.

---

I just received my SR1 560 and SR1 360 today, the SR1 560 radiator measures 153mm tall. I don't think that any radiator mount will work as the Phobya 3 x 140mm radiator stand is 2mm thick at the bottom. It appears that we must soft mount these SR1 140mm radiators, more or less using neoprene stips to sandwitch them into the bottom section.

If you're looking to spend a little more on the build, I suggest getting some CM Excaliburs for rad fans and blacking out the labels. I think the mesh carriage the Excaliburs have would match your sleeved tubing very well.

Quote:

---

Originally Posted by nksharp

http://www.silverstonetek.com/produc...id=292&area=en

From their manual :

204mm(witdh) x 630mm (length) x 154 (height) - Page 41 on the manual

You would be able to fit them just fine I would imagine. I will be getting this case next week and plan on having a quad 140mm and a triple 140mm using 120mm fans.

---

Any update on getting a 4x140mm radiator in the bottom section of the Silverstone TJ11 and how much vertical space was left after the 140mm quad rad install? I'm wondering how close Silverstone's measurements are! It's going to be a close fit anyway since my XSPC 140mm rad stands are 2mm think adding to the SR1's 153mm tall, that's 1mm more than the measurements! :eek:

Very impressive build.

I just have some question about your hose sleeving.
Would you mind to tell me what kinda hose, hose size, fitting size, sleeving, and if there is, then heatshrink?

I saw several people doing hose sleeving with Compression fittting, and I really like those looks, but
I dunno how do they tighten those fitting.