-
Pff, AsRock board performs equal with GBT790GX. I have both and I can use the exact same settings on both boards and hit the same limit with my 9950BE. AsRock board never had post issues with high volts. Had used 1.65V for days without problems on water. 5-7-7 timings are defaults if you only select 533 mode. They may have tried 800 mode with 1T, which works quite well since 1.2 bios. Board has one issue, the reported voltages are too high, it report's ~0.04V higher voltages than i could measure with a DMM. DMM results where ~0.3V above bios settings in 1.5V range. So I think they used 1.5V in the bios at 3.8GHz.
I don't have vista 32bit here, otherwise I'd ran an comparison. CB10 however does not really care about 5-5-5-15 or 5-7-7-24.
EDIT: Saw they used 1.525V in the bios.
Their memory bandwidth is a joke, did they use the correct slots for the ram?
-
3Dmark06, 3DMark Vantage, DOOM 3, FEAR, Crysis, Lost Planet CrossFire Benchmarks of Phenom II X4 940 using 2 X HD 4850.
http://my.ocworkbench.com/2008/amd/P...benchmarks.htm
Don't know if they are legits, but that review is very bad...childish. Waiting for reviews from legit sites.
