ek supreme and bitpower 3/8 5/8 1/8 wall fittings.

very nice mate!!!!

good work vincent

Vincent...when will that be available for the mcw60?

Which one...ST transfer base or???

The adapters you used to fit the fittings on the mcw60.

It's what we call ST transfer base(ST transfer Adapter), now it's available in Stainless but Silver Shining one will be available in next week...

could we get a pick of this mate?

Here it is...but is in Stainless...

Quote:

---

Originally Posted by BP-Vincent

We heared that...we are doing this...off-center rotary adapter coming soon...

---

please let us know when these will be available.Any eta?

I need a few of them

as two don't fit on my chipset blocks

http://i212.photobucket.com/albums/c...worklog028.jpg

cheers

Where is an online store I can get my paws on these. I just might delay my build again just for these.

Quote:

---

Originally Posted by FuriousSalesman

Where is an online store I can get my paws on these. I just might delay my build again just for these.

---

We will ready Silver Shining ST Transfer Adapter for Worldwild market within two week.

Stainless series only acceptable in Taiwan/Hong Kong...We don't know why:(

Quote:

---

Originally Posted by disruptfam

please let us know when these will be available.Any eta?

I need a few of them

as two don't fit on my chipset blocks

cheers

---

We are checking the design within next three days...Hope it can be ready after Cebit..I Hope...:)

I have some on the way, soon as they show up, I'll post some pics
(sometimes it's good to be on the fast track. . )

Looks like i'll be delaying my build to get a couple of those adapters!

Quote:

---

Originally Posted by NaeKuh

Also the accelerators need to be cleaned. They come very messy at the factory.

Heres what i mean..

http://i125.photobucket.com/albums/p...a/IMG_0848.jpg

So i would take that thing apart and clean it up with some 1000 grit sand paper.

---

Thats splatter from it being laser cut and is really really bad that it has been left there as it's sharp and very uneven and can pinch the o-rings. Bad bad Eddy.

Oh if that was on any part of the undercargie of an airplane you'd die on landing, the splatter would casuse an oxidisation fracture on the material and then load then just split it open and ka boom ya 6 ft under. Part of my job is removing of splatter

The problem with the compression fittings not fitting on MCW60....

1) Is that 1/2" only or 1/2" AND 3/8"?
2) Is that only when G80 adaptor plate is needed for MCW60?