Few days with 2x1GB G.Skill PC4000HZ - full OCing report!

Quote:

---

Originally Posted by Martin Cracauer

I initially had bad results until I switched the sticks, apparently I have one stick weaker than the other.

---

Same here, switched them and solid 3D at 270 3-4-4-8. 2.9v

Owww. 2.9V is excessive for that ram..

Quote:

---

Originally Posted by demonR6

Owww. 2.9V is excessive for that ram..

---

Whoops, actually 2.8v. Running 272 no problems 3280Mhz on my Opty 146 @ 166 Divider.

Quote:

---

Originally Posted by Martin Cracauer

Well, I have a 4 MB S3 PCI graphics card in there ;)

Right now I have them under Windows for the first time, but I only use Windows for clockgen/a64tweaker/prime95.

http://www.cons.org/cracauer/oc-scre...hz-3-4-4-8.png

---

i have 8MB S3 i think...... :)

@Martin Cracauer and FlyBoyGeo,

Not too bad, guys! Anything more left in them?

Quote:

---

Originally Posted by bachus_anonym

@Martin Cracauer and FlyBoyGeo,

Not too bad, guys! Anything more left in them?

---

Probably not in mine, I fiddled quite a bit, messing with all the usual suspects parameters. I get 260 MHz 3-4-3-7, though.

I noticed that on my SLI-DR/623-3 this RAM goes better on A64 settings I used on my TCCD than at what the BIOS autodetects for the HZ. My screenshots are with the good parameters.

I'll try a different CPU but in the past the CABYE I used above was my best memory controller CPU.

I know I have one weaker stick than the other, I'll see what the stronger one can do alone. I might order a second set to make one good set and one medium set.

@bachus_anonym

get my g.skill from production date 0604xxxxx - oc not so good, only 260 MHz :(

do you know what kind of UCCC (week code) are used ?

Quote:

---

Originally Posted by Rhum_JM

@bachus_anonym

get my g.skill from production date 0604xxxxx - oc not so good, only 260 MHz :(

do you know what kind of UCCC (week code) are used ?

---

I also have a 0604 kit and they're not doing too good :(