Printable View
So which sticks to get if you are willing to have slightly less cpu HT but beter timings
I do not play games so I do not care about 3dmark scores and benchmarks, I care about performance because I use 3d programs which requires good I/O bandwidth which I think CAS timings matter
It doesnt have to be G Skill either ;)
Might be a case for HX. At lower MHz it will certainly have better timings than the UCCC in the HZ.Quote:
Originally Posted by Kaiser_Sose
No, I/O bandwidth is limited by the devices to amounts where a little more or less RAM performance doesn't matter at all. Even slow RAM transfers 3 GB/sec. PCI bus max is 133 MHz/sec. Cracking down on RAID with PCI-X or PCIe will give you 180 MB/sec in a raid0. No RAM bottleneck there.Quote:
I do not play games so I do not care about 3dmark scores and benchmarks, I care about performance because I use 3d programs which requires good I/O bandwidth which I think CAS timings matter
It doesnt have to be G Skill either ;)
great answer Martin again :)
with you i can do my other job since i am so busy cuz xmas comes :) many orders!
Just got a set of HZ today and cranked up to 264 my cpu maxes out at about 2640 or so,I like this set so far:toast:
very nice to see itQuote:
Originally Posted by Prospector
Got the HZ for Xmas and am still playing with them but 270x10 32m pi stable at 3-4-4-7 2.7v. My 3700 maxes out at 2.85 and am priming now at 256x11. 14hrs in and so far so good. So far this is at 2.7v, 2.5v or 2.6v did not help any at all.I will push for 275 to 280x10 after i find a prime stable spot to fall back to. Now to try and fit the powerstream psu in my case.
IS it true that recent HZ kits are not OC well?
If that is the case, does GSkill have any 2 gb kits that are for OC?
not really, i still see many ppl up to 270 280 no problem, if your mother board and CPU is strong, you might push ur ram to run higherQuote:
Originally Posted by Kaiser_Sose
i got the recent patch of HZ from newegg,(got it tuesday) i was stucked at 270Mhz and can't go any higher with any means...... maybe it is only me.....Quote:
Originally Posted by G.S Technician