Opteron 146 CABNE + Aluminum Mousepot revisited! 3600mhz!

Quote:

Originally Posted by bachus_anonym

Ain't got no 32M, AFI? Gimme some eye-candy :D
Results look better session after session, man! Your determination is just great! Impressive :toast: :up:

Would have ran it if I had the ice ;) I must have spent an hour pulling cords and stuff trying to make it work. My DFI board decided to start POSTing with no video every 5 minutes. I hope to run it again next weekend with a new win XP setup that actually works and do a 3.5ghz 32m run (keeping the DI right will be a real pain for 20 minutes though lol) and a 3.55 8m. After that it's onwards to 40k 3d01!

I'd use server 2k3 but I don't have a copy ;) And as for the rams, those were the tighest timings I could get to run. Errors all over in mem test (160 first loop then it gets out of hand second loop) but they're 32m stable up to 260 and I haven't tried more. 1m @ 265 I know but that's it.

Maybe with a copper tube, SP2004, 2V, and some other trickery I can hit the magic 3640mhz that will put my ram at it's ideal 260mhz :D 1.9v is already a lot of heat for this poor aluminum tube. If my temps go up 2C idling after 1m at 3600mhz it hangs. I doubt I could even SS 3625.

Quote:

Originally Posted by moddolicous

Nice run afireinside. I stil say u should give dbench a try @ that speed. Would probably be under 100. Back on topic, Try these settings, they may help u get into 22's. Read preamble: 5.5, Max async latency: 7, TRFC: 12 and idle cycle limit: 0.

I'm not running Dbench on dry ice. That's the dumbest thing I could run.

Idle cycle 0 = crazy errors in mem test
TRFC 12 = doesn't run on UTT
async 7 and preamble 5.5 = don't run on opteron. I need 8 async 7 preamble set in BIOS to break 3050mhz.