hi!
any news from rav286k1 yet?
i will will check the readout again if it is much too high.
Printable View
hi!
any news from rav286k1 yet?
i will will check the readout again if it is much too high.
Hi Masterpain,Quote:
Originally Posted by masterpain
sorry but until my friend does not return from his holiday I can't mod the motherboard. ;)
no problem, i think i will keep hold on this board because of the upcoming venice cores.Quote:
Originally Posted by rav286k1
Did you check the resistance with the power on or off?Quote:
Originally Posted by masterpain
power was off, iirc, i will check again, i am currentl sitting next to my mainrig, i will check again.Quote:
Originally Posted by persivore
edit: its again the same value. power was off during measurement.
Ok, thanks for checking. If I have got the right point, there might be a problem finding a multi-turn variable resistor with a high enough value to only produce a small voltage increase at maximum resistance.Quote:
Originally Posted by masterpain
since my an8 went uo in smoke for no reason it will take a month to get this mod runinng.
@rav286k1: any news from your side?
Hei... there will be new board that features higher voltage
the ABIT AN8 Fatal1ty SLI
Vdimm : 2.55V - 3.55V
Vtt voltage: 1.25v ~ 1.75v and DDR/2
http://www.xtremesystems.org/forums/...chmentid=30296
mmh, nice.
i will get one as soon as its available in germany.
Can someone please solder a 100 KOhms trimmer 25 turns to pin 14 OR to pin 8 of the Winbond W83320S IC to see if it change the Vdimm?......One of those two legs (14 or 8) must be the Vdimm mod........First try on oin 8 and if it doesn't works, try on pin 14.......Beware to pre-trimm it at it's MAXIMUM resistance (ex. 100 KOhms) before soldering it.....The other Winbond IC (W83310S) with the 8 legs is for the VTT - autotracking and autocorrecting the VTT - .....So no VTT is needed for this mobo.... ;)
i will try it as soon as my board is back from abit.
still waiting.... :rolleyes:
@ tictac: is this theboard you where talking about?
http://www2.abit.com.tw/page/en/moth...939&DEFTITLE=Y
yes it is :yepp:
there are also cheaper veersion with 3.55V vdimm
AN8 Ultra :up:
AN8 SLI :up: