Printable View
Strange both mine even the defective one @100% no pwm hook up. Insanly nice flow completly pushed bubbles out of my rads in an hour or so. When both hooked up 2 minutes no large bubbles could also drain 250 ml res in 1 Mississippi.Quote:
Originally Posted by mlee49
Sent from my X10a using Tapatalk
hehehe a Mississippi...
I actually skipped over the Rev1 res for this pump.. No ETA on the Rev2 res yet.Quote:
Originally Posted by Big Myke
Its a very common measureing standard.
I'm gona start the petition to standarize flow in ml per mississippi
The liters/gallons per minute/hour way to confusing.
Sent from my X10a using Tapatalk
well Mississippi's would make ALOT more sense than the medieval imperial crap you use now! :rofl:
until you start using fractions, 5/8 Mississippi :rolleyes:
Is that a sober mississippi or a happy hour variety...might need a conversion factor..:DQuote:
Originally Posted by Creekin
That's just a mississi :-)Quote:
Originally Posted by Creekin
Sent from my X10a using Tapatalk
Considering this crew happy hour......Quote:
Originally Posted by Martinm210
Sent from my X10a using Tapatalk
wow thanks, looks like its alot better then the ddc 3.25's??? running from 4.75gpm.. It has more flow but less head then the specs i listed for the 3.25 below ?
Technical Data:
• Maximum Flow Rate: 2.3GPM (8.7L/min)
• 1.5 GPM at 9.4 feet of head (2.9M)
• Maximum Head Pressure: 16.2 feet (4.9M)
• Motor design: Electronically commutated, brushless DC, spherical motor Voltage Range: 8 to 13.2 VDC
• 9 VDC required to start
• Quiet operations at ~31dBA
• Maximum system pressure: 21.75psi, 150 kPa (1.5 bar)
• Temperature range: Up to 140F (60C)
• Acceptable media: Domestic hot water, water/Glycol mixtures and other media on request.
• Corrosion resistant
• Warning: Do not run pump with out fluid
Are there G14 threading on the bottom port of the reservoir? Installing a Male to male bp fitting that rotates seems more logical in my setup than their forced 2,4,6,8,10,12 oclock fixed rotations.
Thanks.
No at least on first revsion it was a clean hole.
Thanks for the necro thread res to suck ne back here.
Sent from my X10a using Tapatalk
No, it's a clean larger hole with an o-ring recess in the base of the reservoir. The way it's designed, the acetal pump top provides support to the base of the reservoir and there is a special metal fitting that distributes the force over a larger area:Quote:
Originally Posted by Big Myke
http://img594.imageshack.us/img594/10/35xdownspout.jpg
It's a good design the way it is to help reinforce that connection and minimize acrylic stress at that connection.
Oh and the rotation isn't fixed. Its a small pin to fix orentaion but its not required. You could leave it out and it would rotate full 360.
Sent from my X10a using Tapatalk
Glad to hear it!Quote:
Originally Posted by MagisD
Good point.:up:Quote:
Originally Posted by MagisD
Update - availabe as D5 Variant now ! :)
FYI, I think you forgot to upload the test result images or something. I can see pictures of the pumps, but nothing about any testing.
Guys is there any way of changing the res for a bigger one ???
Thanks a lot
Sergio