I saw it in a thread a few weeks ago i think it was like pre mixed coolant (primochill?) turned on the pump and bam it turned white or something, op should clarify or scrap my epic memories.
Printable View
Holy resurrecting worklogs! "Dead Men" walking!
Quite a surprise to this bumped. :)
I reckon dead men merrily walking around these parts is in spirits with Halloween soon approaching. :D
Heh...No. T'was a mishap that happened last year. It looked so much like milk, It would have been a crime if I didn't take pics.
Recipe for Milk Coolant:
(Serves one loop)
Ingredients:
1 NEW Thermochill Rad
As much as your loop holds of clear liquid (distilled water or uncolored coolant. I used clear Primochill PC Ice).
High flow pump (speed dial optional)
Directions:
Flush your new Thermochill rad once (which is what I did) or not at all (which is what I almost did).
Place in loop using clear liquid.
Set pump at highest flow (if feature available).
You've got milk. Results will vary depending on amount of flux in rad. Turn off loop = Milk gone.
Lesson:
Flush Thermochill rads until the next appearance of Haley's Comet.
http://lh5.ggpht.com/_QLiEm5wyerY/Ss...0/DSCF3203.jpg
http://lh5.ggpht.com/_QLiEm5wyerY/Ss...0/DSCF3209.jpg
http://lh6.ggpht.com/_QLiEm5wyerY/Ss...0/DSCF3207.jpg
Thanks RADCOM :up: This rig is still running perfectly but is due for an overhaul soon....or at least a makeover.
Your memory serves you well Onoff :up: Could not have explained it better myself. You even nailed the Emeril Bam!