İntel stock fan Sp1m 13s
Printable View
İntel stock fan Sp1m 13s
You wont achieved much more with that mbo... <450 FSB is good,but everything behind that is a hall...Max I achieved stable is 440MHz FSB
Mofo fsb max 600+
whats ambient or i call bull:banana::banana::banana::banana::banana:
Damn nice Overclock on Stock heatsink man. I had to take a double take when I saw that. Good work!:up:Quote:
Originally Posted by EXPANDER
nice Overclock
Wait,is that X38 or p35?Quote:
Originally Posted by EXPANDER
either he lives in the arctic circle or thats is xtreme bull:banana::banana::banana::banana:
4 GHZ on stock cooling, come on
really nice q6600 you have there... LOL i could get those clocks too .. but with a 2 stage cascade.. F**kn fsb wall :D
My Max is 4644.4Mhz on Water with 1.8v on 4 Cores:D
http://valid.x86-secret.com/show_oc.php?id=324586
http://www.hwbot.org/listResults.do?...true&limit=100
No Team.......
That´s nice :D
Quit posting bull.Quote:
Originally Posted by 71 (Bryan)
You do not have to sit outside in -degrees (Celsius) to boot/post a CPU-Z screenie.
24/7 *full quadcores loaded* volts&clocks at stock or "high-end" cooling (air/water) is a totally other "planet".
It is not what the threadstarter is showing us here.
It is "only" a "fairly decent" G0, at most. Not "The Golden Chip".
To get that rating he has to show a proven max."stable" clock using OCCT or Prime95 run.
Which probably will be well below 4.0Ghz.
On Intel stock, probably below 3.6Ghz.
:)
is there anywere some review or article about thit Cooler???
could he be in Single core mode?
aye, i can run my g0 6600 at a wide range of speeds upto 4.5ghz on my phase cooling, fine for hours in desktop and for a few pi runs. However run seti on full tilt all all 4 cores and it can crash within a few seconds!
Respect! Very nice oc with air cooling!!
I had my Q6600 (G0) at 3,6GHz for a short time. Vcore set to 1.36 Volt.
But I had some problems at first with ocing with my Gigabyte X-38 DS4, that's why I'm a bit careful with ocing more. I wanted to have over 15k points at
3D M 06.But I didn't reach it...I made 14.928 points wich was kind of disappointing... :(
Definately not mate , on the Overclockers Australia forum we only have 5 submitted q6600 clocks in the 41xx MHz range and not one 4.2Ghz or above (thats air and water cooled - no phase etc).Quote:
Originally Posted by KTE
Any non-phase clock above 4.2 is mad !!!
Good stuff guys .
:up:
dfi p35 ut t2r/g 680 fsbQuote:
Originally Posted by quake6
dfi x38 lp lt t2r/g 600+ fsb:up:
So you can OC the q6600 better on the p35's?
Nice job btw! WOW... stock cooler run is sick o_O
DFI P35 Good fsb.Quote:
Originally Posted by drizzt5
x38 normal fsb :up:
post screenies we all wanna see;)Quote:
Originally Posted by EXPANDER
I dont know why you ask why he's temps are so low.
My frieds Q6600 with Zalman 9700 NT @ 3.6Ghz is running at 23ºC [ambient 21ºC]....
Its all got to do with how you apply thermal paste, and if the cooler properly hugs the Chip
Yikes !!
There's no way he's running at 23c idle with 21c ambient. Not at 3.6ghz. (1.30v+) Sorry. He's either full of it or not receiving proper readings.Quote:
Originally Posted by Eppikk
Also, as for the original pic... Look at the temp. reading on his HDD lol. It's probably like 10c in that room.
get a portable ac n blow some cold air on cooler lol:rofl:Quote:
Originally Posted by Systemcepe
Quote:
There's no way he's running at 23c idle with 21c ambient. Not at 3.6ghz. (1.30v+) Sorry. He's either full of it or not receiving proper readings.
Also, as for the original pic... Look at the temp. reading on his HDD lol. It's probably like 10c in that room.
-----------------------------------------------------------------------
Vcore at 1.375, i didnt believe it either, especially because he said that at stock clock it was at 16ēC wich is Impossible IMO.
He was using a Asus P5E3 DX inside a 3T Xtrem Engine case (250mm fan on side, 2x 3000RPM 80mm on rear and one 120 case fan on front)
Tough i think its bull, cuz my E6300 @ 3.39Ghz with an AC unit next to it only manages to get as low as 24ēC (with TR2 Cooler)
But my P5E3 DX and Q6600 kit is ordered, lets see how i fare with the very same cooler ¨+ ac unit :cool:
Also he had his CPU at 28ēC @ stock speed with the Intel Stock, os i guess the readings are right (but since the guy is afraid to "KILL" his CPU, he wont let me run Prime for 10 min to see where the temps get to :P )