Sorry people, please refer to: http://www.xtremesystems.org:16080/f...6&postcount=23.
I need to consolidate :)
Sorry people, please refer to: http://www.xtremesystems.org:16080/f...6&postcount=23.
I need to consolidate :)
very nice work!!!
For the sake of consolidation, please refer to this thread. Thanks.
Teaser...
http://www.gam.net.au/pcmods/images/CIMG4288.33a.jpg
Is that a Antec SX1240 Full Tower case?
Chieftec BX-01-B, but the removable drive cages, fan brackets and basic design is shared by many different manufacturers I've noticed... probably all Taiwanese though. ;)Quote:
Originally Posted by msgclb
For more shots/info on the actual case and its minor mods, check here.
The bottom section of your case is identical to my case. The section above has enough room for the power supply and a 92mm fan. The door latch is the same.Quote:
Chieftec BX-01-B, but the removable drive cages, fan brackets and basic design is shared by many different manufacturers I've noticed... probably all Taiwanese though.
My Zaiman CNPS9500 is not living up to expections and I'm looking for a replacement. I had my doubts that any of these large coolers would fit. At least now I know that the ThermalTake Big Typhoon will fit.
In the photo above, you can just see the end of one of the horizontal brackets, above which, the PSU sits. You can also make out the extremity of the duct, which is about 25-30mm beyond the top of HSF. Note that I have replaced the TTBT stock 120mm (25mm thick) fan with a PanaFlo 120mm (38mm thick) fan, so there is a little more clearance than that if you keep the stock fan. (I'm very happy with the TTBT. It does a great job!).
GAM...that PC is filthy!, give it a clean dammit!