Printable View
yes we can do that. change the value to CL5, and that is what we are going to do. however, becasue the bios issue and all of the SPD can not set at CL4.. that just not right. we are discuss with Gigabyte and hope they can fix itQuote:
Originally Posted by Richard Dower
btw we don't have problem for P5B
So do we RMA the RAM then?...like can we send our memory to G.SKILL and have it reprogrammed?
also we can reprogram the SPD if already purchased
yes that is rightQuote:
Originally Posted by Richard Dower
fill out the RMA form and return to rma@gskill.com
we will reprogram for you
That is good to know, have a Celeron 326 coming next week, i will build the PC and see if it will boot...if not i will RMA the RAM, thank you!
Hey...if i bought this:
http://www.newegg.com/Product/Produc...82E16820145528
Would i be able to boot up and change the timings?...then install the G.SKILL ZX kit?
i bought HZ sticks......coming in on monday ......i'll report in how i go with them
question
default system settings for Conroe/allendale CPUs is 266MHz*multiplier
the RAM should be able to handle 266MHz CAS3 right 1.8v?
HZ works fine for me on Gigabyte DS3 with Allendale
i got the ZX kit for my DS3 and i can report the same issue.
no boot because of 1 thing. and this is an easy thing to prove.
the default vdimm on all of the Gigabyte boards is 1.9v
this has NOTHING!! to do with CAS 3. NOTHING. infact even dropping the FSB to 200mhz or less the ram STILL will NOT boot at CL3 at no time does this ram boot at CL3. its all about the voltages.
if that was the case then i'd love to have anyone of you explain to me WHY when i change the voltage to 2.2 and boot it boots with CL4 ?
your comments of the system booting to CL3 are false and unfounded.
not only that the ram will not boot at CL4 800 unless its given 2.2v NOT 2.0- or 2.1 as the label claims.
it wont even boot at 2.1 @ ddr667 ? someone care to explain that to me ?
the fact is and still is that this ram needs 2.1 or higher to boot.
my kit wont boot on anything less than 2.2v. that is +.04 in the bios vdimm and EVERYTHING for SPD left on Auto.
once i do that i can boot into windows where every tool known to the community reports the ram running at 4-4-4-12 and thats Auto SPD
i need to know how Gskill wishes to handle this as every conroe board available uses 1.9v as its defualt vdimm. (out of the ones i know of)
i just got it today and am i to be expected to send this ram back to you after less than 8 hours of testing ? infact if i so desired i would catagorize this as non working and non compliant.
i see no reason to do that, i expected to have a working product and gskill knew about these issues and yet still sell them as they are.
will the DS3 work with (G.Skill 1GB 800MHz DDRII NR Series) without BIOS flash? i think it is CL5 timing.