DFI Infinity 975X/G - VMCH & VFSB mods

Any news on a vdroop or vcore mod?

Quote:

---

Originally Posted by Cpt.Planet

Any news on a vdroop or vcore mod?

---

Which VCore controller chip does the board use?

Quote:

---

Originally Posted by celemine1Gig

Which VCore controller chip does the board use?

---

I will do some digging and see if I can find anything.

Vmch Is not boing to blow up :D

You just need to use a PCI gfx card beound 1.98 or 2.05 I belive. :)

And DONT boot above 2.05 Just boot at 1.95 and Ajust in windows :)

This is only as I recall it, So maybe not 100 % acurate :p

http://img364.imageshack.us/img364/5...0088my7.th.jpg

It reads
primarion
px3538cdsg
cs0155.01
5105 KR

I found where the vcore measure is.
http://img48.imageshack.us/img48/9427/img0099ld5.th.jpg

Can't get the full datasheet unfortunately. Primarion only has general information online. :( I can't help you ATM.

Quote:

---

Originally Posted by celemine1Gig

Can't get the full datasheet unfortunately. Primarion only has general information online. :( I can't help you ATM.

---

Thanks yea I saw that to.

I wish you good luck...

Have you tried to email them ?

Quentin

Quote:

---

Originally Posted by quent

I wish you good luck...

Have you tried to email them ?

Quentin

---

I just sent a request for the full datasheet. We will see what happens.

is there any vFSB pencil mod? :)

Quote:

---

Originally Posted by The Stilt

http://www.armada.fi/Infinity-975X/I...-975X-VMCH.jpg

Use PC Health menu to monitor the voltage.
The reading reported by the PC Health menu fully agrees with my Fluke dmm.


http://www.armada.fi/Infinity-975X/I...-975X-VFSB.jpg

The picture says it all.

Have fun :D

---

I am a total volt mod noob. Where are the ground points on this mobo or the nearest to the VMCH solder point?

Quote:

---

Originally Posted by raju

You can pencil mod the nb voltage too, I already have 1.95 going through mine. Sorry I'm a bit new to the terms here.
So what does the Vfsb adjust then?

---

Is there a pic for the pencil mod?

I need vDroop mod for DFI Infinity 975 X/G

no reply :eek: