Printable View
Bazx congrats!!
I bet this feels awesome !!!
man you have no idea how many times i have almost given up on this refrigerantQuote:
Originally Posted by sdumper
it has been a real challenge
but you are bang on i am very pleased:D
thanks
here is a suicide shot from tonight not an oc just off the multi
http://valid.canardpc.com/show_oc.php?id=528459
http://www.benchtec.co.uk/images/baz...oaded/cpuz.gif
Holy smoke, bazx. This is a real accomplishment!
Hats off to you, sir! :up:
Thats awesome I want a Phenom II so bad right now but the wife is already having fits about my tool purchases :)Quote:
Originally Posted by bazx
I guess CPEV do it's work, am I right ? :p:
Nice numbers :clap:.
Can You compare how many *C You gain after swap from modded tev to cpev (idle/load) ?
Does CPEV used with R14 needs frequent tuning ?
Regards
Peter
i must say peter the cpev solution to my R14 problems is by far the bestQuote:
Originally Posted by piotres
and i do have a working cascade now @-122
Great job bazx!!;) You are an inspiration. :clap:
I'm guessing you used tes2 with 02 orifice on first stage and a tes2 with 00 (future change to 01) orifice on second with a cpev on third.
Was second stage a tes2? I know you said tev for r23, which a tes2 isn't.
hi ron
tevs used
TES 2 danfoss (02 orifice) R404,TEB2 danfoss (01 orifice) R23 (from Cold_ice), cpev R14(from piotres)
data on TEB 2
http://hr.refrignet.danfoss.com/RA/P...selectedTab=IN
cold_ice shop
http://www.kaeltetechnik-shop.at/Exp...-55C-Danfoss_1
i put the 01 in the TEB2 last night so will be vacuuming down today and testing
will let ya know how that went
Any news on 01 orifice results for the TEB2?:)Quote:
Originally Posted by bazx
Would you have still used the 02 orifice in the TES2 if you were using r507 :yepp:
Quote:
Would you have still used the 02 orifice in the TES2 if you were using r507
yes i think i would ron
with the 02 orifice whist i have lost some temps with this one it has given me an us-shakeable 1st stage @ -37
the 01 is in the 2nd stage now which has lead to a rise in temp also -73 but again this is now very stable
the knock on effect of this has been an increase in high pressure in the 3rd stage to 15 bar @ full load with a temp of -125
the unit is now full stable at this temp @ around 250w
i would add that if i looked back i can see some things i would change
1. i would go for cpev on all stages tevs are good but have restricted my refrigerant choices
2.refrigerants: i would use/tryed the following instead of the one i have used
R402 or R507/R170/R14
imo opinion the above would have given me some slack on each stage
and would more then lightly held load on each stage @ lower temp