anyone know how to do this? i can take pictures of my board if this will help but i dont know what to take a pic of.
for those of you who dont know the vmem on the board goes up to 2.9 and i would like to use 3.2
Printable View
anyone know how to do this? i can take pictures of my board if this will help but i dont know what to take a pic of.
for those of you who dont know the vmem on the board goes up to 2.9 and i would like to use 3.2
Are you able to take a high-res pic of the whole board? I don't own this board, but I wouldn't mind finding out how this mod is done :)
PMed DDTung and got this reply:
"REfer to the BD7II Vmem mod. This board uses a similar Winbond chip(with 4 extra pins) but the Vmod is still using the STR1sense pin.
DDTUNG:cool: "
The BD7II Vmem mod is known as a hard one, which kinda sucks. Soon as I get my camera back, I'll take some high-res pics, but I'm not sure I want to risk the board doing a tricky Vmod...I'll read up more on the BD7II and see how hard it is.
Only problem is Randi tried that mod and was unsuccessful( bye bye rda), he didn't state if the mod was wrong for this board, or if he made a mistake with his work. If I knew that was the exact same mod, then it is tough, but feasible........ but didn't like the fact that we now have 1 burnt up rda+ in our midst.
boooo! :)
How do I have to mod the Chip to get 3,2V?
http://www.winbond.com/PDF/sheet/W83301DR-O.pdf
cobase,
MrIcee explained it a bit here:
http://www.xtremesystems.org/forums/...3483#post73483
Mind you, he failed w/ this mod...seems as tho the leg was too brittle :(
Ouch! :mad: Looks rather nasty, this mod.