Hello:
I am thinking about putting block to my 9700pro, but I see a problem, and are the most of block hits with the dissipators of the memories... exists some that does not have this problem?
Salu2.
Printable View
Hello:
I am thinking about putting block to my 9700pro, but I see a problem, and are the most of block hits with the dissipators of the memories... exists some that does not have this problem?
Salu2.
no most blocks fit onto it without a problem... i think the 9700p has the same mounting holes as a 9800p, so a maze4 or swiftech block would do fine.
In maze the tubes go just upon the memories... I need something that is the sufficiently high, or that it fence a little turned... something like this
Salu2.
The Swiftech MCW50 is designed to make room for RAM sinks, so you should be fine unless your RAM sinks are outrageously tall.
ok, what it does not convince of that block to me is the tube system, the one that s ele cannot put clips not gives me much security... but we go, I am read that the yield is very good
Salu2 and thanks
silverprop HL high enough?
Very good block :D , it has very good dot... to see if encounter some site in which they sell here in Spain... although I do not discard mcw50, because this it has dot of being expensive...
Thanks
Salu2.
For "chikitano",you can buy it in Spain in http://www.baluma.es, they have shop near of Granada in AlmerÃ:banana:a and in Málaga.
I´m from Granada too.
A lot of people says that SilverProp HL is the best block for VGAs and I have a friend that can confirm that.He test Maze4,Swiftech and Silverprop and now has SILVERPROP and say is the best.
I hope this can help in your decision. :)
Yes, you have helped me to decide :D , and he is not expensive as i thought,to have if with the olive collection the sufficient...
Saludos y gracias.
silverprop hl is the best.. it will still get in the way of the ramsinks on two bga's. But they ALL do this. so just grin and bear it. you cna put on short heatsinks or cut down your current ramsinks.. it should be too much of an issue at all.
The zalman ram hatskink are good?? they have got 13x13x13 mm
Salu2.
they look ok... the ocz and a couple other of the copper ones look better to me... copper cools much better than alluminum.. it has roughly twice the cooling ability..