Printable View
Hi,
Just want to show ya some pics of my Vmod. Default Vcore was 1.77 and right after I connected the 10K POT It was reading 1.83V.
I'm currently at 1.93V/470Mhz, What kind of voltages are the people running out there air cooled? Is 1.93 too high for air cooling?
Regards,
KODE.
One more:
Another angle:
Whole card:
Looks nice .....
Hmm..I would think it would go >470 :D
nice, but pay attention to that atx cable which seems to near the mod wires ;)
Yes, I would either lay the VR on its side, or reduce the length of those wires so they go "straight" to the VR pins.
If one of those wires gets knocked off, that floating wire could hit a few things and cause a short circuit.
Very clean soldering job btw. ;)
at what point do you measure voltage