HomeMade CPU Kit Problem

Hi there.

I bought an homemade kit from a Poland guy known by one friend of fiend mine

Although i think this was bad constructed.. it has to little space and i cant put the screw there. Check the photos:

http://img357.imageshack.us/img357/8171/img5765pz9.jpg

http://img222.imageshack.us/img222/7262/img5766vl3.jpg

http://img222.imageshack.us/img222/9367/img5769eg9.jpg

http://img222.imageshack.us/img222/381/img5773yz6.jpg


Solutions?
Thank You

Just enlongate the partial hole so it becomes a slot. Then use wingnuts or a large sized washer for that corner.

original mach mach 2 enclousre has 72mm (the same as lga holes spacing) so no possible to made mouting without moding standrd enclousure
http://www.xtremesystems.org/forums/...3&postcount=28

of course I could move holes(maybe) but in this way evap will not be on center of cpu surface