D-Tek Fuzion and Compression Fittings

Hi, I'm trying to rebuild my watercooling setup. ATM, I'm using 1/2 ID 3/4 OD Tygon tubing on my D-Tek FuZion cpu block. They're tied down with zip ties, and I don't like the look.

Since I'm buying a new case, I'll need new tubing, so before I decide what tubing I'll need, what compression fittings will work on the d-tek fuzion? I have a friend who tried using 1/2 ID 3/4 OD on his d-tek and it didn't fit. Will 3/8 ID 1/2 OD compression fittings fit?

Thank you in advance for you help guys :)

Yes, 3/8ID 1/2OD compression fittings fit... at least the Koolance ones do. Not sure about Bitspower, but I don't see why they wouldn't. Atomman has compression fittings on his Fuzions.

I talked to the guys at Petras and they said Bitspower fittings don't fit either fuzion block. And I was asking about the 3/8-5/8 not the 1/2-3/4. I don't think they will fit. I never got a straight answer about it when I asked on the forums but I'm sure that Alex and Quoc know what they're talking about.

Atomman's Skulltrail loop uses Koolance compression fittings. 3/8"ID, 1/2"OD.

http://www.atomworks.com/public/boar...s/leakTest.jpg

thanks guys :) so, 3/8 ID 1/2 OD fittings fit.

@polizei

what brand of fittings did atomman use on his fuzions? --- sorry, kinda read over the part where you said koolance fittings. thanks :)

are the koolance's fittings AL????

Quote:

---

Originally Posted by nealh

are the koolance's fittings AL????

---

Nope, brass nickel plated. :up:
They went the right route when they made those. :)

Quote:

---

Originally Posted by smee

Nope, brass nickel plated. :up:
They went the right route when they made those. :)

---

thanks