DFI P965-S - Vmod needed

Hello all,

First of all I excuse myself for my English who is very very bad, I will try to express me clearly.

I would like to practise Vmod on my DFI P965-S, indeed, this chart is like all the others, it suffers from Vdrop, to a lesser extent that certain P5B but there is roughly 0.04V difference between the voltage in full and idle.

I would like to remove this Vdrop if that is possible to lower Vcore in idle slightly.

Certain people already said me that is not necessary, but the forum was not a forum in which I had confidence, that think?

If you have need for photographs or other known as it me.

Thank you

Yes.. a vdrop mod would be nice ...

Thank M3kk

Thus a vdrop MOD would not be useless.

There is a problem, I do not have any idea of what it is necessary to do.

I already saw drop MOD on P5K, but the chipset is not the same one

http://www.ixtremtek.com/ixtek/Vmod/...oop-pencil.jpg

On is this photograph it enough to connect two different points, drop MOD could be carried out in the same way (by connecting two point) on P965?

I would like to thus know “where” to carry out this Vmod, and especially on which points.

As in my post preceding, if you need photograph of the PCB I would post them to you.

Thanks

Sorry for the double post but nobody can help me? :(

The dfi's control chip's info page is not available to public so its virtually unmoddable. Sorry :)

Thank you for the information, I thus give up any attempt at Vmod…

There is nothing excessive it is just 0.04V, but, I am perfectionist and I wanted this Vmod so that my Vcore is the least variable possible.

Thanks for all :yepp: