Krullet's SLI containers' rebuild | worklog
Hi
Krullet has sent me his SLI kit for complete rebuild it to use 2 containers on G80 series :D . So I've put here new bases from mine 3.0 series SLI containers ...I let to tell rest pictures :D .
http://www.members.lycos.co.uk/piotres2/krullet/1.jpg
http://www.members.lycos.co.uk/piotres2/krullet/2.jpg
Containers staight from Krullet's house .
http://www.members.lycos.co.uk/piotres2/krullet/3.jpg
"Old" kit after cleaning from insulation (it had been sticked, gah, dirt work :shakes: ) .
http://www.members.lycos.co.uk/piotres2/krullet/4.jpg
http://www.members.lycos.co.uk/piotres2/krullet/5.jpg
After unbrazing old bases ..inside had been much dirt, sth like very heavy oxidations ...I think that had reduced heat transfer pretty good :( :( .
http://www.members.lycos.co.uk/piotres2/krullet/6.jpg
http://www.members.lycos.co.uk/piotres2/krullet/7.jpg
I must to cut tubes to fit them for new bases which are ...
http://www.members.lycos.co.uk/piotres2/krullet/8.jpg
BIGGER :yepp: (new vs old bases)
http://www.members.lycos.co.uk/piotres2/krullet/9.jpg
Thiner container brazed ...
http://www.members.lycos.co.uk/piotres2/krullet/10.jpg
Thicker near done ...I need to make a mod with add some plate to make tube thiner in down part :) .
http://www.members.lycos.co.uk/piotres2/krullet/11.jpg
http://www.members.lycos.co.uk/piotres2/krullet/12.jpg
Just before cleaning ...
Tomorrow I hope to clean, polish, and insulate them, so I hope to finish work ;) .
Regards
Peter
