P5W DH - Chassis Intruded! ???

My board is crazy:

It's new, arrived today, but when i power on, after the bios post:

Chassis Intruded !
Fatal Error... System Halted!

And i can't do anything, no access to the bios, nothing. I read the manual, but the Chassis Intrusion jumper is in default. Already claered cmos, but the same.:(

I don't now what to do.

Any ideas?

Sorry about my English.

First of all what bios no is wriitten on the bios chip? Mine came with a 401 which wouldn't work till it was updates to at least 601 or up (currently i'm on 1101). Still haven't got a conroe though so i bought a celeron to tide me over and flash it

Yes, it's writen, it's 0701, and it recognize perfectly my E6600, but that is not the problem.

check out your manual for chassis intrusion detection header pins.
probably you miss a jumper from there.

Quote:

---

Originally Posted by caater

check out your manual for chassis intrusion detection header pins.
probably you miss a jumper from there.

---

With or without jumper the problem is the same.

Quote:

---

Originally Posted by safm

With or without jumper the problem is the same.

---

Remove that thing, clear cmos, pull battery, wait a bit.

Then redo w/out intrusion and try.

I've had a similar problem, took out the CMOS battery, reset both the Chassis Intrusion and the CMOS jumpers and the problem was fixed.

Quote:

---

Originally Posted by Igor01

I've had a similar problem, took out the CMOS battery, reset both the Chassis Intrusion and the CMOS jumpers and the problem was fixed.

---

i took out the battery abou 14 hours and, restarted but problem still there. 1 question, when we remove the cmos battery, it cleans the cmos, correct? because when i removed the battery i didn't move the cmos jumper to clear position.

Quote:

---

Originally Posted by safm

i took out the battery abou 14 hours and, restarted but problem still there. 1 question, when we remove the cmos battery, it cleans the cmos, correct? because when i removed the battery i didn't move the cmos jumper to clear position.

---

You have to:

1. Remove the battery
2. Change the position of the clear_cmos -jumper for 10 secs
3. Change the jumper back to it's normal position
4. insert the battery back
5. Voila! :woot:

mine did this, just restarted it a few times and it corrected itself..

Quote:

---

Originally Posted by safm

i took out the battery abou 14 hours

---

You're a patient man.
Even a few minutes are enough...

lol 3 secs is fine to take out the battery but ensure you have removed the power cable from the power supply too or it'll keep it's settings. Simple as

Nop,

Don't work with battery, without battery, with power, without power, clear cmos i don't know what to do.

Tomorow i'll go the store and changed the board.

But wich one:

> Asus P5W DH Deluxe
> Gigabyte GA-965P-DQ6

MY System is:

OCZ GameXStream 700w
Conroe e6600;
Asus P5W DH Deluxe or Gigabyte GA-965P-DQ6
2 GB Gskill 6400HZ
Club 3d 7900gt
XP-90c

Thanks everyone for your help.

once more, sorry about my english.