kgk
Xtreme Member

I too have had some family issues and have not been able to return your last message. I have not had the chance to try the shell I made on my P6T7 board and I may not get one for a while but if you would like to try it out, along with the foam insert I made, I will send it to you free and your feedback will be my proof of concept. I have the vapochill LS, no longer in print, sucks, so if you have the unit it should fit. I have also ground down two 90 degree edges on the shell and the foam to clear the capacitors on the board. This will be at your own risk of course but I believe it will work, also, in my setup I went with electrical tape surrounding the socket and I formed a foam "ledge" to seal around the edge of the heat spreader. Send me a mailing address and we will get this ball rolling. Again, sorry for the late response.

Sorry about the delay, I've had some bad family issues recently and I am now just returning to these forums and my projects. I have not yet mounted the vapo on my P6T7 because I am just putting the finishing touches on the custom foam insert. I am also fabricating some brackets for the dual chips south of the cpu to use another phase unit on (the original DC vapochill xe core). I will keep you posted.