Tab Content
No Recent Activity

2 Visitor Messages

  1. View Conversation
    I like doing my write-ups with blocks paired up (I have a Luna Rev.A due here next week, that will be the Sapphire's partner) so that I'm not spamming the WC section I don't do PQ testing (no manometer, they're $500 for the ones that can do full-time liquid duty), but I do have calibrated Dwyer flowmeters in my testloop and use those with 6 different pump settings--at all pump settings the Sapphire Rev.A had the highest flow (easily). It's a block that is extremely low restriction and is pretty blind to flowrates as well, so I really wouldn't worry about it flow in your loop unless you have some very restrictive components elsewhere. That said, from other tester's data I've see, its pressure drop curve is in the vicinity of an MC-TDX/Fuzion V1 with no o-ring or nozzles (somewhere between the two), both of which should be in Martin's estimator.
  2. View Conversation
    Hey Boogerlad, I'll see if I can get some clickable thumbnails up on the tutorial within the week as well as the Solidworks scene setup. The people over at Bit-Tech have been keeping me heavily occupied with requests as well
Showing Visitor Messages 1 to 2 of 2
About Boogerlad

Basic Information


Total Posts
Total Posts
Posts Per Day
Visitor Messages
Total Messages
Most Recent Message
10-25-2009 12:20 PM
General Information
Last Activity
07-27-2019 06:22 AM
Join Date