Tab Content
  • chew*'s Avatar
    Today, 03:57 AM
    chew* replied to a thread After a long needed hibernation in AMD
    probably overkill but I ran hci 2000% coverage as well.
    129 replies | 25408 view(s)
  • chew*'s Avatar
    12-05-2019, 01:14 PM
    chew* replied to a thread After a long needed hibernation in AMD
    Ported settings to gskill royal = pass. Also locked frequency and retested aida and the anomaly went away so must have been a fluke with...
    129 replies | 25408 view(s)
  • chew*'s Avatar
    12-04-2019, 05:28 PM
    chew* replied to a thread After a long needed hibernation in AMD
    Finalized settings on the giga Aorus master. Included a screenshot with voltages and timings. I also took out my 15-15-15-35 3600 gskill kit tossed...
    129 replies | 25408 view(s)
  • chew*'s Avatar
    11-26-2019, 05:13 PM
    chew* replied to a thread After a long needed hibernation in AMD
    Trend continues cross vendor and all the way down to slacked 3200 mem speeds. Now ive swapped memory to gskill royals. if same outcome I think the...
    129 replies | 25408 view(s)
  • chew*'s Avatar
    11-24-2019, 06:25 PM
    chew* replied to a thread After a long needed hibernation in AMD
    Above mem clock/timings failed prime. Not surprising. It was from ryzen dram calculator which never worked on taichi x370 nor x399. tested...
    129 replies | 25408 view(s)
  • chew*'s Avatar
    11-23-2019, 05:01 PM
    chew* replied to a thread After a long needed hibernation in AMD
    I went back and retested taichi. If you recall at one point I had a radiator strapped to an ac and had it water cooled and could not do XFR peak all...
    129 replies | 25408 view(s)
  • chew*'s Avatar
    11-23-2019, 12:26 AM
    chew* replied to a thread After a long needed hibernation in AMD
    I think heat may have been a contributing factor other day. I dropped temps down to 65f in house and the results are much closer now. Really it...
    129 replies | 25408 view(s)
  • chew*'s Avatar
    11-22-2019, 10:55 PM
    chew* replied to a thread After a long needed hibernation in AMD
    this went 28 hours so now we can do some comparisons.
    129 replies | 25408 view(s)
  • chew*'s Avatar
    11-22-2019, 01:05 PM
    chew* replied to a thread After a long needed hibernation in AMD
    gear down is enabled by default. to run spec on 15-15-15-35 3600 one needs to load xmp set IF 3600 set vddr 1.35 set geardown disabled and let her...
    129 replies | 25408 view(s)
  • chew*'s Avatar
    11-21-2019, 06:15 PM
    chew* replied to a thread After a long needed hibernation in AMD
    ran this off. xmp vs tuned. nice little gain there considering same speeds. tossed in an untuned 3800 run to. maybe ill go tune that next.
    129 replies | 25408 view(s)
  • chew*'s Avatar
    11-21-2019, 02:47 PM
    try silicone based conformal it will hold to ln2 temps just fine. can bench with a river on card or board I just build dams with eraser around dim...
    2 replies | 3178 view(s)
  • chew*'s Avatar
    11-20-2019, 07:15 PM
    chew* replied to a thread After a long needed hibernation in AMD
    Ok i'm starting to like this board, I think it may clock memory a bit better than taichi, couple things I played with were getting past the IF 3800...
    129 replies | 25408 view(s)
  • chew*'s Avatar
    11-20-2019, 02:55 PM
    chew* replied to a thread After a long needed hibernation in AMD
    ok 21 hours is gud enuf for me, got a couple baseline stable profiles to work with, now I can fool around a little.
    129 replies | 25408 view(s)
  • chew*'s Avatar
    11-20-2019, 10:21 AM
    chew* replied to a thread After a long needed hibernation in AMD
    Been putting in work with lifeline in apex with the 5700 vanilla the past couple weeks :frag: have run into a few hackers but I think any game has...
    129 replies | 25408 view(s)
  • chew*'s Avatar
    11-19-2019, 07:32 PM
    chew* replied to a thread It was a good run in Xtreme News
    I was posting on overclock.net but got tired of trolls. Honestly they are everywhere so I keep a very low profile now. Auto overclocking, cpu's...
    164 replies | 56677 view(s)
  • chew*'s Avatar
    11-19-2019, 07:25 PM
    Thought win 10 = all scores rejected by hwbot for ryzen?
    4 replies | 1468 view(s)
  • chew*'s Avatar
    11-19-2019, 05:32 PM
    chew* replied to a thread After a long needed hibernation in AMD
    As I suspected board and memory were not the limitation for pulling 3600 or better with the 2700x. Board repeatedly f9'd me no matter what I tried to...
    129 replies | 25408 view(s)
  • chew*'s Avatar
    11-19-2019, 04:47 PM
    chew* replied to a thread After a long needed hibernation in AMD
    Ok so I swapped the 3900x in and tried setting porting. It appears that the chips are so similar that if the settings are stable for the memory and...
    129 replies | 25408 view(s)
  • chew*'s Avatar
    11-19-2019, 03:09 PM
    chew* replied to a thread After a long needed hibernation in AMD
    Took a couple hours to figure board out, one thing to note it was picky with my flaky dims best stick needed to be closer to cpu weaker stick...
    129 replies | 25408 view(s)
  • chew*'s Avatar
    11-17-2019, 06:59 PM
    chew* replied to a thread After a long needed hibernation in AMD
    Playing with gigabyte master and the 2700x currently. There is some deviation from requested vddr and termination and what you actually get however I...
    129 replies | 25408 view(s)
  • charged3800z24's Avatar
    11-15-2019, 01:14 PM
    It is one killer chip!
    2 replies | 546 view(s)
No More Results

19 Visitor Messages

  1. View Conversation
    Hey, tried MWLL yet?
  2. View Conversation
    Hey Simon, how have you been? Are you planning on being at CES this year?
  3. View Conversation
    hey simon, havent seen ya around here lately. tried to reply to an exchange we had a few months back but your pm box is full again
  4. View Conversation
    thx for the update on the contest prizes

    i was going to send a pm but your box is full
  5. View Conversation
    What's been going on man! My daughter and I met you at Quakecon this year.
  6. View Conversation
    Simon, Thanks for the link. I am so slow, I forgot to check here for your responce, I kept waiting on a PM LOL. We are a reseller for HP mainly and just need to help keep our company up on what AMD offers. Thanks again.
  7. View Conversation
    Hey Simon what's up?
    Is Pete Hardman still with you guys?
    If so what is his e-mail so that I can send him an e-mail, been a while since we spoke.
    And you have to try get him on the forums if he is still around.
    How is everything going with you? Looking forward to the other Simon Says competition Collages.
    Daniel
  8. View Conversation
    Hows it going Simon
  9. Jay, always best to begin at the beginning. First, join the reseller program. There are free resources galore to get ramped on AMD reseller solutions. Through that program you can request ongoing support.

    Are you a VAR or Systems Integrator reselling commercial systems from leading OEMs? Join our channel partner program and get access to sales and marketing tools, valuable market insights, industry publications and customer success stories that explore key issues shaping the channel today.

    Register for free to gain full access to AMD's sales and marketing support.

    http://sites.amd.com/us/alliance/Pages/information.aspx
  10. View Conversation
    Do you have any idea how I can get info on a partner program for the company I work for? Intel has reps and trainers coming regualrly and I am trying to push some AMD servers etc. I sold our first AMD systems this year (in a 8 year company history). 1 2S Shanghi server from HP and 14 AMD Phenom HP desktops. It would be nice to have someone come in and show road maps and technology benefits from other than myself. Sorry to bother you, I can't find it on the website.

    Jay
Showing Visitor Messages 1 to 10 of 19
Page 1 of 2 12 LastLast
Page 1 of 2 12 LastLast
About 64NOMIS

Basic Information

About 64NOMIS
Biography:
Born in Cleveland. Born to write code. Got sidetracked. College in Chicago & Dallas. Austin & AMD since 2002.
Location:
Austin, Texas
Interests:
Woodwork, Speaker Building, Spousal Servitude, Offspring, Mountain Biking, Swimming, Xtreme Computing.
Occupation:
I try to solve really challenging problems at AMD.

Signature


Statistics


Total Posts
Total Posts
599
Posts Per Day
0.15
Albums
Total Albums
1
Total Photos
1
Visitor Messages
Total Messages
19
Most Recent Message
04-11-2011 09:33 PM
General Information
Last Activity
11-06-2018 07:37 AM
Join Date
12-03-2008
Referrals
2

44 Friends

  1. 96redformula 96redformula is offline

    Xtreme Enthusiast

    96redformula
  2. BeepBeep2 BeepBeep2 is offline

    Xtreme 3D Team

    BeepBeep2
  3. Benny Lodewijk Benny Lodewijk is offline

    Team ID - Indonesia

    • Send a message via MSN to Benny Lodewijk
    • Send a message via Yahoo to Benny Lodewijk
    Benny Lodewijk
  4. beta beta is offline

    Xtreme Member

    beta
  5. biglipzit biglipzit is offline

    I am Xtreme

    • Send a message via MSN to biglipzit
    • Send a message via AIM to biglipzit
    • Send a message via Yahoo to biglipzit
    • Send a message via Skype™ to biglipzit
    biglipzit
  6. boblemagnifique boblemagnifique is offline

    Xtreme X.I.P.

    • Send a message via ICQ to boblemagnifique
    • Send a message via AIM to boblemagnifique
    boblemagnifique
  7. CAL930 CAL930 is offline

    Team"KATANA"

    CAL930
  8. charged3800z24 charged3800z24 is offline

    Xtreme Cruncher

    charged3800z24
  9. chew* chew* is offline

    Brilliant Idiot

    chew*
  10. crazydiamond crazydiamond is offline

    Xtreme Addict

    crazydiamond
Showing Friends 1 to 10 of 44
Page 1 of 5 1234 ... LastLast