Conversation Between Salamndar and AceBaran

1 Visitor Messages

  1. Mother Board ( EVGA X58 Classified E-760 )
    Drivers ( )
    Bios ( S61J )
    CPU ( 920 D0 )
    CPU Cooler ( Swiftech Apogee XT )
    Memory ( Corsair Dominator GT 2000 9-9-9-24 1T )
    PSU ( Corsair HX1000W )
    GPU ( GTX295 )
    Drivers ( 190.56 )
    Operating System ( Windows 7 64 )


    Frequency Control
    CPU Clock Ratio ( 2021 )
    CPU Host Frequency (Mhz) ( 216 )
    MCH Strap ( Auto )
    CPU Uncore Frequency (Mhz) ( 3447,5 )
    CPU Clock Skew ( 0 ps )
    Spread Spectrum ( Disabled )
    PCIE Frequency (Mhz) ( 105 ) Do not go above 100 with SSDs <---just read this, why is this


    Memory Feature
    Memory Speed ( standard )
    Memory Control Setting ( Enabled )
    Memory Frequency ( 646 / 2:6 )
    Channel Interleave Setting ( 6 Way )
    Rank Interleave Setting ( 4 Way )
    Memory Low Gap ( Auto )
    tCL Setting ( 9 )
    tRCD Setting ( 9 )
    tRP Setting ( 9 )
    tRAS Setting ( 24 )
    tRFC Setting ( 74 )
    Command Rate ( 1t )


    Voltage Control
    EVGA VDroop Control ( Without VDroop )
    CPU VCore ( 1.28 )
    CPU VTT Voltage ( +100 )
    CPU PLL VCore ( 1.650 )
    IOH PLL VCore ( 1.800 )
    DIMM Voltage ( 1.50 )
    DIMM DQ Vref ( +0mV )
    QPI PLL VCore ( 1.20 )
    IOH VCore ( 1.10 )
    IOH/ICH I/O Voltage ( 1.50 )
    ICH VCore ( 1.12500 )
    VTT PWM Frequency ( 250 KHZ )
    CPU PWM Frequency ( 800 KHZ )
    CPU Impedance ( auto )
    QPI Signal Compensation ( auto )

    CPU Feature
    Intel SpeedStep ( Disabled )
    Turbo Mode Function ( disabled )
    CxE Function ( Disabled )
    Execute Disable Bit ( Disabled )
    Virtualization Technology ( Disabled )
    Intel HT Technology ( disabled )
    Active Processor Cores ( All )
    QPI Control Settings ( Enabled )
    QPI Link Fast Mode ( Enabled )
    QPI Frequency Selection ( 4.800 GT/s )
    OC Recovery ( Disabled )

    PnP/PCI PCI Express
    Maximum Payload Size ( 256 )

    Power Management Setup
    ACPI Suspend Type ( S3 )
    HPET Support ( Enabled )
    HPET Mode ( 64-bit )
Showing Visitor Messages 1 to 1 of 1