PDA

View Full Version : 3D Mark Help?


JAWS
06-11-2002, 03:24 PM
GF3 Ti200

My last 3Dmark bench was rated at 8020 after all my tweaks. It was overclocked to 210/510, so I bumped it up more to 215/515. I ran the test again and the score was 7665. Does anyone have a clue on what happen? Should I back it down? Thanks
OPPAINTER
06-11-2002, 03:32 PM
Not sure, maybe the memory went to high, when your mem is to far overcl:banana::banana::banana::banana:ed it tends to screw up the score.

OPP
DexterHolland91
06-13-2002, 06:35 AM
I agree with OPP, when you overclock the memory too high it can start to decrease your score. This used to happen to me when I benched with an MX400.
Chong345
06-13-2002, 08:48 AM
i've been having the same problem but with my FSB. Or maybe it was my vid card but I get no artifacts.
JAWS
06-13-2002, 09:18 AM
What advantages does someone have after a volt modding the VideoCard. Do you need Xtreme cooling afterwards? (water)
AndrOvr
06-13-2002, 09:33 AM
You can gain more MHZ out of it :D
If u mod the card, to give u a bit more volt. than the default, u dont need "Water" but if u put too much volt u have to start thinking about watercooling the card ;)
DexterHolland91
06-13-2002, 10:03 AM
JWS - Depends on the card and the cooling. Some cards are just pointless to volt mod, like the GF2 MX400, but the GF4 on the otherhand will gain lots from a volt mod, assuming it's cooled properly.
JAWS
06-13-2002, 10:56 AM
Are these volt mods done with fixed or variable resistors? If they are fixed, how do you control the voltage?

I gotta tell you this sounds interesting!
Chong345
06-13-2002, 01:32 PM
ok so far I can only get to 322 Stable on my GF4 ti4600. So I guess my cooling sucks? I shouldn't do a volt mod? I have a crystal orb and system temps are at 22-24C.
DexterHolland91
06-13-2002, 09:06 PM
With air cooling it is still possible to get more out of your GF4 though it would be better to cool it better.

JWS - Variable is much smarter

This volt mod on my Leadtek ti4600 brought me from 330/710 or there abouts stock to 357/785 volt modded and watercooled. This is an A2 core but i'm still certain I can get more out of it.