charlie
02-11-2003, 08:47 AM
All,
I just fired up my mcw50t and it seems to be ok...
But when I turned it on the first time, I heard a little snap sound.
I'm using a 5 gallon resevoir and a submersible pump pushing about 200gph. Now after a few hours, the water heats up to about 28-32C. But this may be from the submersible pump. I can't feel the back of the pcb, as I have it insulated. I observed a fluctuation on my 12v rail as I disconnected (briefly) my tec power connector from the psu. I know I can do it by removing the block from the card, but then I'd have to jump the psu...ideas?
C
I just fired up my mcw50t and it seems to be ok...
But when I turned it on the first time, I heard a little snap sound.
I'm using a 5 gallon resevoir and a submersible pump pushing about 200gph. Now after a few hours, the water heats up to about 28-32C. But this may be from the submersible pump. I can't feel the back of the pcb, as I have it insulated. I observed a fluctuation on my 12v rail as I disconnected (briefly) my tec power connector from the psu. I know I can do it by removing the block from the card, but then I'd have to jump the psu...ideas?
C