]JR[
02-06-2003, 01:20 AM
Have posted this on my usual forum but the wider audience might bring more suggestions/comments/builds
A little elbow grease created this...
http://www.phjrw.34sp.com/direct1.jpg
http://www.phjrw.34sp.com/direct2.jpg
http://www.phjrw.34sp.com/direct3.jpg
Anyways sealed it all up today ala pics, hopefully you can see the white of the tec down the barb ok? Will leak test tomorrow, then run on saturday. Used movable stainless plates for the hold downs so theyre easy to swap for other hole positions, p4, and gfx aswell.
EDIT : The tec is a drift 0.8
]JR[
A little elbow grease created this...
http://www.phjrw.34sp.com/direct1.jpg
http://www.phjrw.34sp.com/direct2.jpg
http://www.phjrw.34sp.com/direct3.jpg
Anyways sealed it all up today ala pics, hopefully you can see the white of the tec down the barb ok? Will leak test tomorrow, then run on saturday. Used movable stainless plates for the hold downs so theyre easy to swap for other hole positions, p4, and gfx aswell.
EDIT : The tec is a drift 0.8
]JR[