G.Skill F1 3200ZX

[Janchu88]

hi

i just bought some of these
http://www.gskill.com/f1-3200phu2-zx.html

as i put down the heatspreader the labeling on the ram told me this
G.skill C32M8G9065F-5

i heard this is some overlabeling from G.SKill so could someone tell me plz which ram was used here? cause i wanna figure out the max safe Vdimm

so far Janchu88

[GSKILL TECH]

hi

i just bought some of these
http://www.gskill.com/f1-3200phu2-zx.html

as i put down the heatspreader the labeling on the ram told me this
G.skill C32M8G9065F-5

i heard this is some overlabeling from G.SKill so could someone tell me plz which ram was used here? cause i wanna figure out the max safe Vdimm

so far Janchu88
no info sorry

[Janchu88]

no info sorry
damn ... i was already expecting this.... :(

[Janchu88]

k ...


so i got the ram now on a DFI .... someone knows where to find some good timings for 24/7 ?

atm with opteron 146@2,8ghz i get 49sec @1m .... ^^

seems like i really need timings ;)

[Janchu88]

cpu is at 10x280 and im using the 140 divider means 200mhz ram clock

therefore i just wanna get the stable settings for 200mhz 2-3-3-6 as it should be....

[Janchu88]

some improvement brought me to 31sec.... :D ;)

but i think there is still something to improve.....

[Janchu88]

now i got another problem ....

seems like the mem controller of my opteron 146 doesnt want the 133 divider above 295mhz HTT ....

i tested 3ghz @100 divider (DDR300) and it worked great but i lost too much bandwith for my taste , even if i get sick timings....

and i tested 2,8ghz @140 divider (DDR400) and it worked great ,too ....

but both 3ghz (133 divider) and DDR400 doesnt work anyway.....
it would be "ok" to mak me use the 120divider using some better timings but not even that worked..... so wtf shall i do?

[GSKILL TECH]

i am not sure what exactly you want to do!

[Janchu88]

i am not sure what exactly you want to do!
so ... i am going to explain it.... :D

I finally found some good timings....

bot now i want to clock my opteron @3ghz (prestested@300x10)

but the mem controller of the opteron doesnt work above 295mhz HTT with the 133divider (ram 2/3 HTT) --->no boot.... (with 120 divider i cant even get 290mhz HTT
using the lowest divider makes me lose to much bandwith but works

the point is that the cpu works @3ghz and the ram was tested @200mhz by me.... bot both 3ghz and 200mhz don´t work together.... and now i dont know what to do ....

PS: is my english that worse? :D ;)

[Janchu88]

i found out where the problem is ... my CPU doesnt want 1T above 280mhz HTT.... so no i need timings for 250mhz with 2T ....plz help