Bad Ram??

[Agent_Johnson]

Hello, I have an Opteron 165, 2gb G.Skill Exteme DDR500, DFI nF4 ultra d (704-2bta bios). I have the cpu @ 2709(301 X 9) (HTT X 3). At these settings my computer will not boot up without backing the memory divider down to 133. 2T or 1T makes no difference. I will list all my settings. Help!

Dram Freq:133
cpc: 1T
cas:3
trcd: 4
tras:8
trp:4
trc:7
trfc:18
trrd: 2
ter: 2
twtr: 2
trwt: 3
tref: 3684
Dram bank: enable

skew control: Auto
Dqs value: 0
Dram drive strength: (currently set to auto-bios says weak1/normal1, weak2/normal2, weak3/normal3, etc. Most settings just say normal but my bios has like 4 normals and 4 weaks. Have tried different settings to no avail)
Dram data strength: 1
ddram response time: normal
max async latency:8
read preamble time:5
idlecycle limit:256
dynamic counter: Enable
R/W queue bypass: 16
bypass max:7
32byte granularity: disable

Dram voltage 2.7
Cpu voltage 1.475

[GSKILL TECH]

do you try 1:1 1st and see it works on 250 or not?

[Agent_Johnson]

Ram will work at 1:1 with everything default including cpu.

[GSKILL TECH]

Ram will work at 1:1 with everything default including cpu.
might be the problem due to the divider, maybe is relate to your cpu

[Agent_Johnson]

Well it boots up just fine and appears stable with 280X9 and 180 divider but goes downhill from here.

[G.S EUTech]

Will 260~270x9 1:1 (200 div) work?

[Agent_Johnson]

Will 260~270x9 1:1 (200 div) work?

No, 270X9 isn't even stable on the 180 divider. I have to back off to the 166.