Pedant
01-24-2003, 05:05 AM
Hi, I recently volt modded my nForce board.
It was a HIP6301 chip so I connected pin seven to ground (the case). Changing the value of resistor doesn't do much - I am now on 10Kohms and only 2.00 volts.
Is it safe to go lower than this? I wouldn't mind seeing what 2.2 volts could do but it probably isn't worth going down to five Kohms?
Thanks.
It was a HIP6301 chip so I connected pin seven to ground (the case). Changing the value of resistor doesn't do much - I am now on 10Kohms and only 2.00 volts.
Is it safe to go lower than this? I wouldn't mind seeing what 2.2 volts could do but it probably isn't worth going down to five Kohms?
Thanks.