Problem with new ram

[Kryta]

Hey I recently purchased some G.Skill F1-3200BWU2-1GBGH 1GB however I have an problem. When I put the gskill ram in I start the computer and it gets to the stage were the windows logo comes up but then it go's to a blackscreen and dose nothing. If I try to boot from CD or floppy it just frezzes soon after it starts.

However I have an few older sticks of ram and I put that in and it works fine.

My PC specs are:
DFI LANPARTY UT nF4 SLI-DR EXPERT 939
AMD Athlon 64 3500+ 939 Venice Core
XFX nVidia 7800GT 256Mb PCI-E
Seagate 80GB HDD
Antec Truepower 2.0 550w EPS PSU

thanks for any help.:)

[rgdiz]

You might clear the CMOS and then select optimum settings in the BIOS and then reboot. This should allow you to boot and you can set your timings after that.

[Micutzu]

Have you set at least 2.7V in BIOS for RAM voltage ? 1GBGH are guaranteed for 2-2-2-5 but in the 2.7-2.9V range.

[GSKILL TECH]

remember set bios to 2-2-2-5 DDR400/FSB200
2.7v~2.9v to see it works or not. if not then you can either replace with the place you purchase or RMA with us

[Kryta]

Thanks for your help, however it still dos'nt work looks like I'll be sending it back to the shop I got it from for replacement.

[GSKILL TECH]

Thanks for your help, however it still dos'nt work looks like I'll be sending it back to the shop I got it from for replacement.
np, and I am apologize for it