Dfi Ultra D need more Vdimm

[Wayway]

Ok I just installed my dfi Ultra -D board and im trying to get it over 3.2v and theres a jumper someone said but I bought it off someone and theres no booklet can some post pics of what I need to do so I can get over 3.2 v thx

[Kunaak]

upper right corner.
the huge jumper, by above the PSU connection.
move that from the left to the right.

you can't miss it.

[Major]

You also have to set special VID to make it the 3.2v and above available in bios

[Wayway]

ok i did that and on my bios it only goes to 3.2 what did i do wrong, Im using 704-2BTA, is that my problem thx

[Major]

ok i did that and on my bios it only goes to 3.2 what did i do wrong, Im using 704-2BTA, is that my problem thx

see above

[politenessman]

ive had a few ultra-d's now have a rev ad0 i have never had to do anything but move the divider to get 3.6v vdimm. also using 704 big toe.

very truly yours,
politenessman

3800 x2 298x10 xp90/panaflo
ultra d sli mod AD0
2x512mb ocz gold pc3200 bh5 249mhz 2-2-7-2 3.4v
2x7800gt sli
sunbeamtech 550watt nuuvo

[Wayway]

i looked in the bios theres nothing there to vid its all vid for cpu , I moved the jumper to the right and still no luck.

[RyderOCZ]

Go into the bios.....set the CPU Voltage to 1.300V.....then set +110%...now save and exit and reboot....back into the bios....now you can see more than 3.2V :)

[Wayway]

ok will do brb with update

[Wayway]

thx guys got it to work , thx Ryder