brwmogazos
01-15-2003, 06:58 PM
Hi,
I got my Vapo PE up and running finally as i cancelled my P4G8X order due to the fact that the mobo will be NOT available for the next couple of weeks....Anyways...used my IT7MAX2 V1 and fired it up...
I used the insulation+ heaters-everything as described in the vapos manual...
From the Chillcontrol i set the Condenser temp to remain @ -25C-Fan speed @ 60% from 75% and left the heaters @ 60%...
Clocked my rig etc etc for a few minutes...
After running my Vapo PE though @ just 150fsb(gonna try to clock in steps from tomorrow feeding the chip with the required voltages only etc and running it @ IDLE in windows...Room temp abou 26C-cpu temp arround -1C sometimes +2 etc(weird...it doesnt really go under -2 @ idle...Is that weird?Anyways...suddently my rig froze...BSOD...after firing my vapo up again it now froze again (did a constant screeching noise as WMP was playing i guess...)...then i did SHUT DOWN my rig and tried to fire it up again.NO GO...tried twice(intervals of about 2 secs) and the system just SHUT DOWN itself again.Waited about 5-10 secs and fired it up again...Now it is running Ok...
I am pushing 1.5V(stock) in my 2.53ghz p4(1.44V under load) and i am wondering if this is a sign of condensation...
If it IS...WHAT should i be doing next?Using ALL of the insulation paste he Vapo Came with?
Now Running @ full load to heat it up and it stays @ 7C to 8C
Thanks in advance guys:)
I got my Vapo PE up and running finally as i cancelled my P4G8X order due to the fact that the mobo will be NOT available for the next couple of weeks....Anyways...used my IT7MAX2 V1 and fired it up...
I used the insulation+ heaters-everything as described in the vapos manual...
From the Chillcontrol i set the Condenser temp to remain @ -25C-Fan speed @ 60% from 75% and left the heaters @ 60%...
Clocked my rig etc etc for a few minutes...
After running my Vapo PE though @ just 150fsb(gonna try to clock in steps from tomorrow feeding the chip with the required voltages only etc and running it @ IDLE in windows...Room temp abou 26C-cpu temp arround -1C sometimes +2 etc(weird...it doesnt really go under -2 @ idle...Is that weird?Anyways...suddently my rig froze...BSOD...after firing my vapo up again it now froze again (did a constant screeching noise as WMP was playing i guess...)...then i did SHUT DOWN my rig and tried to fire it up again.NO GO...tried twice(intervals of about 2 secs) and the system just SHUT DOWN itself again.Waited about 5-10 secs and fired it up again...Now it is running Ok...
I am pushing 1.5V(stock) in my 2.53ghz p4(1.44V under load) and i am wondering if this is a sign of condensation...
If it IS...WHAT should i be doing next?Using ALL of the insulation paste he Vapo Came with?
Now Running @ full load to heat it up and it stays @ 7C to 8C
Thanks in advance guys:)