View Full Version : 300MHz DDR1
Bob21
11-23-2005, 07:51 PM
what would you buy for overclockability?
http://www.newegg.com/Product/Product.asp?Item=N82E16820231035
or
http://www.newegg.com/Product/Product.asp?Item=N82E16820231015
any other suggestions for 2x512mb?
I'm not really sure what is good anymore, these will be used on an MSI K8N Neo2
looking for 300MHz HTT 1:1 decent timings
if you really need that speed out of your ram, out of those 2 buy the kit thats gaurenteed to do it
[XC] moddolicous
11-24-2005, 07:45 AM
Yea, I'd go with what IYP said. You could always use a divider and get some low-latency ram.
nn_step
11-24-2005, 04:32 PM
If you must have the speed, make sure to get the one that is gaurenteed
Daved+
11-24-2005, 04:56 PM
http://www.newegg.com/Product/Product.asp?Item=N82E16820220140
I guess that one is guaranteed to do 300Mhz. Anyone have anything bad to say about it?
nn_step
11-24-2005, 04:58 PM
nope I have a set.. Just remember to put a fan near them...
Daved+
11-24-2005, 06:27 PM
nope I have a set.. Just remember to put a fan near them...
Do they get that hot... or is it just in case...?
May I know what timings are you running and what volts?
nn_step
11-24-2005, 06:34 PM
2.5-4-4-8 T1 at 2.8v..
and just in case...
Daved+
11-24-2005, 08:26 PM
Can't you get it stable with less voltage?
Bob21
11-24-2005, 08:30 PM
so are the TCCD chips still some of the best stuff out there? or is there something better I should be looking at for a 2x512 configuration.
nn_step
11-24-2005, 08:35 PM
Can't you get it stable with less voltage?
not at 315mhz
Daved+
11-24-2005, 09:45 PM
not at 315mhz
Oh, I thought we were on 300Mhz, lol.
Do you remember how many volts you needed for 300Mhz?
PS: Thanks for all the info!
nn_step
11-24-2005, 09:53 PM
I think it was 2.75v ... I haven't used that speed for quite a while so I am not sure.