my cooler is almost finished

[bowman1964]

well been months and i am close except the case to finish but here is a little something to look at.but showing my progress in these forums for months but i am thinking about joining extreemes 3d team so i thought i would show you guys.
procooling thread (http://forums.procooling.com/vbb/showthread.php?s=&threadid=4327)
phase-change thread (http://www.phase-change.com/phpBB2/viewtopic.php?t=18&postdays=0&postorder=asc&start=0)

well every one wants to see my loaded temps on the cpu so i switched out to a tbred cpu.and finaly got mbm to work and set the temps.i ran a stressing program to maximize heat output. max temp was -17c loaded measured in the cpu diode.if you look you will see the low was -24c that was at idle so i lost 7degrees between max load and idle.my block only lost 1 degree but that is probley about right.
-14c is the temp measure at the cpu socket under the grease and insulation pad,if you notice it only looses ant 3degrees from -17c to -14c because of the insulation it doesnt see the actually cpu die temps.
by the way chiller is at -24c and video peltier is showing -24 to -20c loaded temps while i was running the program.and also chilling the northbridge to a cool 5c or so .i regualte the north bridge temp buy adjusting the vavle and slowing the water flow from the chiller.:) :D
http://members.fortunecity.com/ajr011/Resize.of.Capture_3.jpg

[muzz]

Looks good bowman!! I've been following your progress over at procool, and your site, and it looks like your almost there man... congrats:toast:

That is alot of effort and $ there, I hope verything works out for ya, and your insulation guide will be a welcome addition to the site also.

Good Luck
You should have a screamer at the top of the charts for certain.

muzz

[bowman1964]

ok well i need some help now guys.i cannt get my r9700 card over 430mhz core.no program i have tried will stick.powerstrip will let me change the core .and if i change the range from 133 to 150 i can move the slider up to 480 and higher but....................it will not stick when i set it.i will slide the mark up to lets say 450.and when i try to set it ,it just resets the clock to 430 is all i can get it to.

i am running win2000pro for fastest marks.
any ideas......?////:confused:

[muzz]

Thats happened to me sometimes, usually I set it to run at like 500 or something hit ok, then drop it down from there....... if you have a wheel mouse it makes it easier to move it down slow( once you have actually clicked on the slider), it has taken a couple tries a few times.

BTW I never used the 130/150 trick. I heard about it, but just used the all the way up to 403 ( or whatever it is) and went to preference and quick setup/rescan........ I believe they do the same exact thing.