View Full Version : OCZ 520W 8-pin power connector might be too short...
Ub3r-L33ch
10-05-2005, 11:22 AM
I'm planning on buying the DFI SLI-DR Expert board when it comes out. I have an OCZ 520W Powerstream with the 8-pin connector. It's on the same cable with the 4-pin but its half way down the cable instead of at the end of it. I'm afraid that in my case and with the position of the connection on the board it wont reach.
Is there any type of cable extension I can get for it?
Dave in Daytona
10-05-2005, 01:18 PM
Of course not, who would ever conceive of an extension cable for a PSU?
Contact OCZ. :stick:
Of course any EPS extension should work, just get a good one with gold-platted connectors.
Or get a soldering iron.
[WARNING: the PSU can hold dangerous currency even after it is unplugged, so don't try this without required experience]
Ub3r-L33ch
10-06-2005, 09:05 AM
Of course not, who would ever conceive of an extension cable for a PSU?
Contact OCZ. :stick:
Of course any EPS extension should work, just get a good one with gold-platted connectors.
EPS extension?
Sorry, I'm not proficient in electronics. :(
Edit: (Proficient, I think thats the word I'm looking for)
Dave in Daytona
10-06-2005, 03:43 PM
EPS extension?
Sorry, I'm not proficient in electronics. :(
Edit: (Proficient, I think thats the word I'm looking for) http://www.google.com/search?sourceid=navclient&ie=UTF-8&rls=GGLD,GGLD:2005-08,GGLD:en&q=EPS+extension+cable :toast:
Ub3r-L33ch
10-06-2005, 05:26 PM
http://www.google.com/search?sourceid=navclient&ie=UTF-8&rls=GGLD,GGLD:2005-08,GGLD:en&q=EPS+extension+cable :toast:
Sweet Ass, guess I wont have to buy a fancy new SLI 600W Powerstream after all... doh :(