View Full Version : Ok...hmm....adjusted OCZ psu pots....
CRUSH-ER
09-17-2005, 09:19 PM
No problem. But what I'm wondering is if there's any way to get these suckers back to the stock factory settings? :stick:
Turn them the other way? :confused:
Maybe i'm missing something ..
lower the voltages to 3.3, 5, and 12 :stick:
CRUSH-ER
09-17-2005, 09:23 PM
No no...I'm not that stupid. I know that. I mean the "exact" reading they were in the bios...when purchased. :rolleyes:
bachus_anonym
09-17-2005, 09:47 PM
Well... See, it's always a great idea to buy a multimeter and measure rails before actually touching them. I would think, that stock could be around 3.4v/5.1v/12.20v.
CRUSH-ER
09-17-2005, 10:02 PM
The OCZ psu's tell you when the rails are within correct range and out of range. Isn't that good enough to not need a multimeter? I ask this because mine broke and I'm in need of another.
RyderOCZ
09-21-2005, 11:32 AM
Crusher,
There is no way to reset them to exactly the way they left the factory...just adjust the POT's very slowly...they don't take much of a turn and make sure all the lights are green on the back of the PSU :)