Tiribulus
05-26-2005, 09:31 AM
Hey folks,
These are probably dumb questions to those who have been using these two for awhile, but its new to me.
1. I assume you can use the SI sata controller as your primary bootable system device using raid 0.
2. I further assume that installation is the same, meaning go into the bios, create an array, F6 at boot up after that and give it a disc with drivers.
The reason I'm asking is because the manual only shows installing the drivers once you're in windows, but I want to install windows on it.
3. Are there any issues with high bus speeds etc. assuming this setup is possible?
I know lotsa guys here have been running this board much longer than I have and appreciate your input.
Thanks,
>>>--Tiribulus-> :D
These are probably dumb questions to those who have been using these two for awhile, but its new to me.
1. I assume you can use the SI sata controller as your primary bootable system device using raid 0.
2. I further assume that installation is the same, meaning go into the bios, create an array, F6 at boot up after that and give it a disc with drivers.
The reason I'm asking is because the manual only shows installing the drivers once you're in windows, but I want to install windows on it.
3. Are there any issues with high bus speeds etc. assuming this setup is possible?
I know lotsa guys here have been running this board much longer than I have and appreciate your input.
Thanks,
>>>--Tiribulus-> :D