PDA

View Full Version : Constructing DI/LN2 container #2


GoriLLakoS
05-15-2005, 04:07 AM
It's only for socket 478 and i only used dremel and black&decker to make them....

Base only 8,9*7cm



http://www.thelab.gr/attachment.php?s=&postid=225867


Open holes and ''scratch'' the base to put the tube...

http://www.thelab.gr/attachment.php?s=&postid=225870


make the inside...it sucks a little,i don't like it...i don't make it as i want to....nevermind...next time better results




http://www.thelab.gr/attachment.php?s=&postid=225879


here the base with the tube on it.....

http://www.thelab.gr/attachment.php?s=&postid=225873

it only needs braze and it will be like this....

http://www.thelab.gr/attachment.php?s=&postid=225875

then i only need to lap it and make it ''beautiful''...:p

bill
QuikSilver
05-15-2005, 04:09 AM
Nice job, good luck :toast:
Jort
05-15-2005, 10:29 AM
nice going so far;)

you might consider drill some holes into the base:)
Dani
05-15-2005, 10:59 AM
Yes, more holes or something :cool:

This is my base (http://koti.mbnet.fi/dani69/Muut/Kipon%20pohja.JPG)
GoriLLakoS
05-17-2005, 04:47 AM
Brazed only with propane....

http://www.thelab.gr/attachment.php?s=&postid=226683

need lapping

http://www.thelab.gr/attachment.php?s=&postid=226686

lapped for an hour...my hand is red...:p

http://www.thelab.gr/attachment.php?s=&postid=227113

over the base.....''make it a little better'

'http://www.thelab.gr/attachment.php?s=&postid=227114

The END....ยจ)

http://www.thelab.gr/attachment.php?s=&postid=227115