View Full Version : Prime95 won't pass Test 1 ?
I can't pass test 1 in prime95 (blend) , After 4 hours its still on test 1 , 0 errors 0 warning, any idea?
I had the same problem on my rig. It stays on test1 for hours. I tested it on WinXP SP1 and it was fine. Not sure what causes that problem, prime95 itself, some other software in combination with SP2 or hardware. I have no problem with SP2 on DFI NF3 + Sempron. Havent tested clean SP2 install yet on my rig.
it continues untill you stop it. I have run it before , im not stupid ;) But test 1 should only take a minute or two... then continue to test 2 and so on..