View Full Version : Line Route
Hardass
11-16-2002, 09:53 AM
What should the route be if running, 226W pelt, 80W GPU, NB Block?
that 226W tec on cpu, 80W tec on gpu & no tec on nb?
best results would be on seperate loops especially keep tec & not tec seperate or you'll heat non tec blocks rather than cool.
if tecs on same loop i'd run cpu > gpu
Player0's tried lots of configs i'll point him to thread :)
Hardass
11-16-2002, 11:17 AM
Thank,s going to get some Y,s and T,s.:)
Player0
11-16-2002, 11:36 AM
You rang? Hehe. I dont recommend Ys or Ts cause you'll get uneven flow through them unless your REAL careful with making tube lenghts and heights the same.
Does watercooling the NB really benefit you? I've never had much performance benefit with that.
My first instinct would to be bypassing the NB all together. And then a waterloop like:
Resevoir -> Pump -> CPU -> Radiators -> GPU -> Resevoir
If adding the NB in, id put it before the GPU...but since theres no peltier on it, its going to get warmer water, and might be better off air cooled. You could run a seperate watercooling loop to it, but...it would have to be REALLY worth it and I doubt it is.