reject
12-22-2004, 10:59 PM
1.to put on sinks with silver adhesive you dont need to do that stuff with the 2.silicone on the legs of FETs do ya?
3.and how long before i can use my board, 2 hours?
4.and will a sink the size of a 1/4 bga do a good job on a small mosfet of that size? i cut my bga sinks in 1/4s and 1/2s, cause my mosfets are all differnet sizes and close together
5.does the vcore PLL need a sink? i dont think it gets too hot but this is a common one to do, it will fit a bga sink so i can use the tape thats already on - right?
sorry this sounds very nooby but im sleepy
3.and how long before i can use my board, 2 hours?
4.and will a sink the size of a 1/4 bga do a good job on a small mosfet of that size? i cut my bga sinks in 1/4s and 1/2s, cause my mosfets are all differnet sizes and close together
5.does the vcore PLL need a sink? i dont think it gets too hot but this is a common one to do, it will fit a bga sink so i can use the tape thats already on - right?
sorry this sounds very nooby but im sleepy