Minnyboy
12-15-2004, 06:12 AM
I've had troubles trying to flash a Leadtek 5900Ultra to a 5950Ultra bios for a while now.
I've tried a few ways but keep getting errors when using wfflash & nvflash.
The error I'm getting is that the ASIC code (or something similar is not the right one & the flashing cannot continue.
I've tried looking around here & other places but am at a loss here.
There must be a few ppl out there that have successfully done this flash I'm talking about.
What I'm asking for is this:
1.) what bios did you use?
2.) what flashing utility did you use?
3.) what are the command lines involved here?
TIA
Any help is appreciated.
Minnyboy
I've tried a few ways but keep getting errors when using wfflash & nvflash.
The error I'm getting is that the ASIC code (or something similar is not the right one & the flashing cannot continue.
I've tried looking around here & other places but am at a loss here.
There must be a few ppl out there that have successfully done this flash I'm talking about.
What I'm asking for is this:
1.) what bios did you use?
2.) what flashing utility did you use?
3.) what are the command lines involved here?
TIA
Any help is appreciated.
Minnyboy