morphling1
11-07-2002, 03:07 PM
Hi, I just made this today. Gpu water block for Gf3, can someone comfirm that holes positions are the same as for radeon 9700 , if they are then this is for this card too, plus I can mill out the the base for that ring around gpu. Did anyone measured distance between top of the gpu core and ring top ? Would 0.1mm clearance be OK.
Anyway here it is:
Those are square pins no to good of a photo.
http://www2.arnes.si/~mlivak/Gf3%209700%20wb/Picture%20001.jpg
Base of the block which could be easily modified for 9700 ring
http://www2.arnes.si/~mlivak/Gf3%209700%20wb/Picture%20003.jpg
http://www2.arnes.si/~mlivak/Gf3%209700%20wb/Picture%20004.jpg
http://www2.arnes.si/~mlivak/Gf3%209700%20wb/Picture%20009.jpg
And here on some Ati 9000 pro card fits perfectly so it will be ok for 9700 too
http://www2.arnes.si/~mlivak/Gf3%209700%20wb/Picture.jpg
Anyway here it is:
Those are square pins no to good of a photo.
http://www2.arnes.si/~mlivak/Gf3%209700%20wb/Picture%20001.jpg
Base of the block which could be easily modified for 9700 ring
http://www2.arnes.si/~mlivak/Gf3%209700%20wb/Picture%20003.jpg
http://www2.arnes.si/~mlivak/Gf3%209700%20wb/Picture%20004.jpg
http://www2.arnes.si/~mlivak/Gf3%209700%20wb/Picture%20009.jpg
And here on some Ati 9000 pro card fits perfectly so it will be ok for 9700 too
http://www2.arnes.si/~mlivak/Gf3%209700%20wb/Picture.jpg