docah
11-01-2002, 09:01 AM
I was thinking of grabbing another danger den 2 block and sandwiching my 226w peltier to create a "water chiller".
I was going to swap a 3 loop setup one loop just cpu block and pump. One loop for the cold side of the chiller and one loop for the hot side of everything. I suppose the cold side and cpu could be on the same loop... but i figgured to allocate for possible additions ... like a second or third pelt sandwich i should seperate the loops.
Am i insane? i think 226W chiller with insulated hose and resevior should yield at least below ambient results. but i'm not expecting much more than a 10c delta.
I already have proper PSU for the peltier i'm just one pump and one dd maze2 short of putting this together.
All this just because i want to make damn certain that i push the 1700+ tbred i'm geting to 2.0+ ghz (i want 2.2but 2.0 is good no?) that and my jinky watercooling needs a serious redesign and this would be a good form of motivation.
I was going to swap a 3 loop setup one loop just cpu block and pump. One loop for the cold side of the chiller and one loop for the hot side of everything. I suppose the cold side and cpu could be on the same loop... but i figgured to allocate for possible additions ... like a second or third pelt sandwich i should seperate the loops.
Am i insane? i think 226W chiller with insulated hose and resevior should yield at least below ambient results. but i'm not expecting much more than a 10c delta.
I already have proper PSU for the peltier i'm just one pump and one dd maze2 short of putting this together.
All this just because i want to make damn certain that i push the 1700+ tbred i'm geting to 2.0+ ghz (i want 2.2but 2.0 is good no?) that and my jinky watercooling needs a serious redesign and this would be a good form of motivation.