japin
10-27-2002, 08:34 AM
I have a pic of the mod i am thinking of undertaking it is blurry but the part of the image to see is circled
http://www.r2-online.com/japin/DSCF0004.JPG
right there there is supposed to be 2 pins soldered there to place a jumper to increase the vcore by 10%.
It is there on some boards and not on others
i was wondering if anyone thinks it would be ok for me to bridge the connection and how would be the best way to go about doing it, i will solder pins on the board and place a jumper.. i can use a very low ohm resistor or i can just solder a small copper wire between them.
Thank you for your help,
Japin
http://www.r2-online.com/japin/DSCF0004.JPG
right there there is supposed to be 2 pins soldered there to place a jumper to increase the vcore by 10%.
It is there on some boards and not on others
i was wondering if anyone thinks it would be ok for me to bridge the connection and how would be the best way to go about doing it, i will solder pins on the board and place a jumper.. i can use a very low ohm resistor or i can just solder a small copper wire between them.
Thank you for your help,
Japin