GigaByte K8N (nonPro - nf3 150) bios - which is the best?

[p4z1f1st]

so, i got my GB K8N-nonPro to surpass the time until the DFI LP-UT250Gb is available in germany :)

so, is there any good BIOS for this board, on which i could maybe set the multi of my 3000+/512kB ? :)

or maybe timing-settings ? :)

[Karnivore]

Haven't really kept up on the Non-Pro version, however I would assume most likely the latest version. As for memory timing, etc, you do know about Control+F1 for advanced settings?


If nothing else you get a bump here.

[p4z1f1st]

WTF ?!

man, i can't flash my bios !

i wanted to flash the F11-Bios (the newest one), but it doesn't work

i apply floppy as boot-drive....but he doesn't take any order....he just says "laufwerk entfernen - beliebige taste drücken" which means (it's german :D)

"please remove disk - press any key"

when i press any key (lol) he gives the same message, after a short-try of make something with the floppy-disk....

aren't there any button-combinations (like with Award-BIOSes Alt+F2) for Pheonix-bios to flash my bios ? :(

[WesM63]

I don't want to sound stupid, but did you set the bios to boot from A: first? I've done it a few times ;)

[p4z1f1st]

yes, i did


i apply floppy as boot-drive

[Karnivore]

try the Gigabyte windows flasher (http://america.giga-byte.com/MotherBoard/FileList/Driver/driver_gbttools_gbt_@bios.exe) , linked from Gigabyte, worked fine for me. Also F12 is the latest official release (http://america.giga-byte.com/MotherBoard/FileList/BIOS/bios_k8np_f12.exe).

[p4z1f1st]

but that's a BIOS for the K8N-Pro

i've the non-Pro

or can i use it, too ?

[Karnivore]

Sorry, didn't read close enough, honestly don't know if the Pro bios is useable on NP, so I guess best to assume NO. However the @Bios windows flasher should still be fine to use...