kommando
08-01-2004, 11:50 PM
Okay im gonna start off in the waterchilling scene again, but with some easy to do, like using an original fridge to cool a bucket of coolant and running it through my setup.
I've been offered a bar fridge from my mate for free and i was thinking of bending the evapourator to fit inside an insulated res. My pump will be inside this res and i will pump water out of the fridge through some holes in the fridge into the setup.
Now my questions are these:
1) If there is a thermostat would it be wise to remove it and if so, how would go about the process
2)How hard will it be to bend the evapourator if i intend to keep the original fridge casing.
3)Should i insulate the outer shell of my res?
Thanks in advance.
I've been offered a bar fridge from my mate for free and i was thinking of bending the evapourator to fit inside an insulated res. My pump will be inside this res and i will pump water out of the fridge through some holes in the fridge into the setup.
Now my questions are these:
1) If there is a thermostat would it be wise to remove it and if so, how would go about the process
2)How hard will it be to bend the evapourator if i intend to keep the original fridge casing.
3)Should i insulate the outer shell of my res?
Thanks in advance.